Anderson RBM1400, Operator'S Manual

Page: 45 / 95

Anderson Group Self-Loading Bale Carrier – Operator's Manual 45
4.5 Adjusting the forks
The distance between the inner and outer forks must be adjusted based on the diameter of the
bales to be loaded.
NOTE: The forks can be adjusted one after the other.
To adjust the position of a fork:
1. Remove bolt A and put it in position D.
2. Remove bolt B.
3. Loosen the C bolts.
4. Use the bolt in position D to slide the fork along the tube.
5. Put the forks in the desired position (see Figure 16 and Table 9).
6. Put bolt B back in.
7. Remove the bolt in position D and put it back in its original position (A).
8. Tighten the A, B, and C bolts.
Figure 15 — Adjusting the Forks