Anderson NWS-660, Operator'S Manual

Page: 43 / 120

41
The hoop speed control is improperly
adjusted.
Move the control forward between
2 and 10.
Tighten the wheel spring.
Check tire air pressure and adjust
if necessary.
The drive wheel slides on the hoop.
Change the tire if it is worn out.
Check oil level. Check for leaks.
The drive wheel does not turn.
Check the condition of the wheel
motor and change it if necessary.
4. The hoop does not
turn or does not turn
fast enough.
The actuator lever does not move
the pointer.
See section 8-adjustment
procedures p.27
The wrapping speed control is at too
low a setting
Increase wrapping speed.
5. The pusher moves
forward at normal
speed but the hoop
turns slowly.
The actuator lever does not move
the pointer.
See section 8-adjustment
procedures p.27
6. The speed control
lever is blocked.
Water infiltration may have caused
the interior to rust.
Take apart the speed control and
lubricate it.
Check that the plastic film roll is
installed as indicated in the
diagram.
The film is not tight enough.
Check that stretcher and spring
parts are in good condition.
Debris have become wrapped
around the rolls or in the stretchers.
Remove the debris and check the
general condition of the stretchers.
The aluminum rollers are dirty. Clean them with penetrating oil.
The rubber roller is damaged. Replace the rubber roller.
7. The plastic film
breaks at normal
temperatures.
The spikes have become rough.
Gently sand the spikes.
8. The plastic film
often breaks in hot
weather.
The stretcher springs are putting
pressure on the hoop.
Unhook the stretcher springs.
The engine key is in OFF position.
Turn the key to ON position.
The remote control battery has lost
its charge or has a bad contact.
Check the contact or change the
battery. Reprogram the remote
starter (see instructions).
9. The remote starter
does not work or has
stopped working.
The Honda engine fuse has burned
out.
Change the fuse.