Anderson NWS-660, Operator'S Manual

Page: 35 / 120

33
How to finish a continuous bale row
1- Wrap the last bale of the continuous bale row in a plastic bag and load it onto the bale
wrapper. The wrapping cycle will take place. Do not forget to release the hydraulic brake
(Figure 6.3).
2- Stop the engine (Do not stay or walk on the machine when the engine is
running).
3- Move part #10 (Figure 8.5) as far toward the front as possible.
4- Remove the ring pin from the pusher plate (Figure 8.12).
5- Take out the 2 unloading posts, located on the left side of the rear chassis. Take the
unloading post with a round rod at the end and place it in the square axle of the pusher
plate with the square holes facing downward. Put the ring pin back in the pusher plate. Push
on the unloading post to manually move the pusher plate forward (about 1m) and add the
second pole and, then move the pusher plate until it touches the bale (at the center) (Figure
8.13).
Figure 8.12 Pusher plate ring pin