Anderson NWS-660, Operator'S Manual

Page: 23 / 120

21
To prevent the hoop from turning during installation, engage the hoop brake pedal, located to
the left of the drive wheel (Figure 6.3).
Figure 6.3 Brake pedal
Remove the pin from the front roll support (Figure 6.4), slide the support forward, and, if
applicable, remove the empty spool. Install the new roll so that the plastic film unwinds as
indicated (Figure 6.5), push the support back in place, and put back the pin (Figure 6.4).
Figure 6.4 Roll support and stretcher
Next, follow the diagram (the same diagram as is on the machine) (Figure 6.5) to thread the
film, first behind the black rubber free roller, then through the 2 aluminum rollers of the plastic
film stretcher. Let approximately 30 cm (12 in.) of plastic stick out past the stretcher.