Anderson NWS-660, Operator'S Manual

Page: 18 / 120

16
4 Moving the Bale Wrapper
Short Distances
Your bale wrapper can be moved very short distances using its own traction. Start the engine
and use the hydraulic control levers (Figure 4.1). According to the options available on your
bale wrapper, there are 4 ways to start the HONDA engine: manual ignition, electronic ignition
with key, electronic ignition with remote control, and electronic ignition using the same remote
control as for remote steering.
Figure 4.1 Controls
When the pusher is in the rear position, it holds the engine throttle lever in “slow” position. To
switch to moving mode, move the lever of the selection valve to “moving” (Figure 4.1). Place
the throttle lever in “high speed” position by removing the ring pin from the throttle lever
(Figure 4.2). Use the “front wheel drive” lever to control the movement of the bale wrapper and
the “direction” lever to control its direction (Figure 4.1). Finally, once you are done moving your
bale wrapper, do not forget to put the ring pin back in the throttle lever (Figure 4.2).
Figure 4.2 Engine throttle lever
Pin