Anderson GB series, Operation Manual

Page: 56 / 79

56 Operation Guide – Grain bagger GB-series Anderson Group
Figure 39 – Bolt adjustment
3. Screw or unscrew the bolt (C) until the desired roller spacing is obtained.
4. Repeat steps 2 and 3 for the bolt at the other end of the casing.
5. Adjust the pressure on the springs if necessary (see Pressure between the rollers, above).
6. Tighten the locknuts and put the hopper back into place.
NOTE: The distance between the rollers must be equal in the
front and in the back.
4.3 End of use instructions
When you are done bagging the grains, make sure the hopper and the compression screw are
completely empty.
Make sure the machine is stable before stopping the tractor. Before leaving the tractor, it must be
locked and the key removed from the ignition.
When you are done bagging or at the end of every day of use, you must clean the bagger to remove
all residue accumulated (see section 5.7).
4.4 Storage
When you aren't planning to use the bagger for an extended period, it is preferable to unhitch the
tractor and store it and shelter it from the weather, in a dry and covered space.
In order to unhitch the machine from the tractor, proceed as follows: