Attaching the plastic to the cut and hold (individual wrapping sequence only)
•
In individual wrapping mode, it is necessary to Install the plastic in both cut and hold systems. To
do this follow the below instructions:
Start the engine of the honda.
Press the green button on the control panel to open the cut and hold mechanisms.
You must then tye a knot at the end of each plastic roll and attach them to the cut and holds as in
the below diagram.
Press the green button #14 on the control panel a second time to close the cut and hold. The hoop
will move after to position itself to accept the bale.
Cut & Hold mechanism (Control panel side)
Cut & Hold mechanism (Opposite side)
