6
3 - BEFORE COMMISSIONING
Warning!
Operating the equipment incorrectly can cause serious injury and damage.
Do not use the machine until you have read "Safety rules".
3-1 Utilization for intended purpose only
The cutting machine may only be used for cutting. Utilization for any other purpose, or
in any other manner, shall be deemed to be
“not in accordance with the intended
purpose”. The manufacturer shall not be liable for any damage resulting from such
improper use.
Utilisation in accordance with the
“intended purpose” also comprises:
-following all the instructions given in this manual;
-performing all stipulated inspection and servicing work.
3-2 Machines set-up regulations
According to test, protection degree of this power source is IP23S. However, the
internal key components must be protected from direct soaking.
Warning!
A machine that topples over or falls from its stand can easily kill someone.
Place machine on an even, firm floor in such a way that it stands firmly.
The venting duct is a very important safety feature. When choosing the machine location,
make sure it is possible for the cooling air to enter and exit unhindered through the louvers on
the front and back of machine. Any electroconductive metallic dust from e.g. grinding-work
must not be allowed to get sucked into the machine.
3-3 Cutting machine connection
- The cutting machine is designed to run on the mains voltage given on nameplate.
- The mains cables and plugs must be mounted in accordance with the relevant technical
standard.
- The power supply socket come with power source is designed to use strictly according to
the marked voltage.
Note!
Incorrect electrical installations can lead to protection fails or partial fails. The
mains plug and socket, and its fuse protection, must be suitable for local power
suppl
