AD-4430B
- 31 -
5.4.
General Functions
In this section, the way of pre-setting and descriptions for the general functions is described.
General functions are divided into groups according to function and are indicated by the
group name with the function number.
NOTE: General functions determine the module performance and all of the settings are
stored in the FRAM.
5.4.1.
The Procedure To Store New Parameters
Step 1 Press the
+
key to enter to the function mode and display
.
Press the
key to start the function mode.
If returning to the weighing mode, press the
key.
Step 2 Press the
key to select the function group to be set.
Press the
key. The function group is as follows
:
Display
Group Name
Basic functions
Hold functions
BCD Interface
Step 3 Press the
key to select the function number to be set.
Press the
key. The current setting value is displayed.
Step 4 When changing data, two methods of parameter selection and digital input depending on
the function are available.
Type
Description of method to change data
Parameter
selection
Only the available parameter is displayed and blinks.
Select a number using the
key.
Digital input
All the digits are displayed and a digit to be changed blinks.
Select a digit using the
key and
change the value using the
key.
After changing data, press the
key. The next function number is displayed.
When the value is not to be changed, press the
key to return to the function
number display.
Step 5 Press the
key. The function number disappears and the display returns to that of
Step 2.
Press the
key again and the new parameters are stored in FRAM and the display
returns to weighing mode.
The blinking decimal point means that the current value is not the weight value.
If a data exceeding the available range is inputted,
is displayed and data is
canceled.
