BASIC SYSTEM OPERATION
BATTERY INSTALLATION
1. Position the TourVox with the front/speaker facing toward your audience
2. Connect MIC-50 or HBM-50 microphone to the 1/4“
MIC jack
3. Turn the TourVox POWER/VOLUME LEVEL knob on. The red POWER LED will
light and remain lit during operation
4. Set the microphone power switch to ON
5. Adjust the volume with the Power/Volume Level thumb-wheel
POWER INPUT JACK
CHARGE LIGHT
POWER LIGHT
1. Remove the battery compartment cover located on the back of the TourVox
by unscrewing the thumbscrew
2. Slide out the battery pack from the TourVox battery compartment
3. Insert ten ‘AA’ size batteries
(alkaline or RC-30 rechargeable batteries) into
the battery pack - rechargeable batteries are recommended. Position the ten
batteries into the battery pack by following
the polarity labels on the battery pack
4. Slide in the battery pack into the battery
compartment and push the battery pack all
the way into compartment
5. Replace the battery compartment cover and
tighten the thumbscrew
NOTE
: PA System CAN Be Used While Charging!
For applications where the TourVox PA system is used frequently, the RC-30 rechargeable
battery kit is available. This kit includes 10 rechargeable NiMH batteries and an AC charging
adapter. When fully charged, the batteries provide approximately 10 - 12 hours of operation.
NOTE:
New batteries must be charged for at least 6 hours prior to first use.
MICROPHONE
INPUT
TourVox Top
RECHARGEABLE BATTERY KIT
Optional accessory
POWER/
VOLUME LEVEL
TourVox Side
BATTERY
COMPARTMENT
For extended battery life, we recommend you fully charge the batteries once each month during
periods of infrequent use. Always fully recharge batteries before storing.
1. Install the 10 rechargeable NiMH batteries into the TourVox (See Battery Installation)
2. Insert the charger plug into the Power Input Jack labeled DC IN on the TourVox side panel
3. Plug the AC adapter into a power outlet for 4 - 6 hours to fully charge
CAUTION
: NEVER recharge other types of batteries. Doing so can result in battery
explosion. Use only rechargeable Nickel-Metal Hydride (NiMH) batteries.
Using the Rechargeable Battery Kit (RC-30)
Cycling the Batteries