Page
14
– Vector Signal Generator – v1.00
March 2021
AnaPico Inc. - www.anapico.com – [email protected]
Getting Started
Included Material
Your signal generator kit contains the following items:
•
Signal Generator
•
Universal power adaptor (AC 100 – 240V) with corresponding country specific plugs
•
Ethernet Cable
•
Memory Stick with graphical user interface for Windows and documentation
System Requirements
The AnaPico graphical user interface requires at least the minimum system requirements to run one of the
supported operating systems.
Operating system
Windows™ 7, 8, 10
Remote
10/100/1000M Ethernet or USB 2.0 Port
Unpacking the Instrument
Remove the instrument materials from the shipping containers. Save the containers for future use.
For a list of material included in the standard package, please refer to chapter
Fehler! Verweisquelle
konnte nicht gefunden werden.
.
Initial Inspection
Inspect the shipping container for damage. If container is damaged, retain it until contents of the shipment
have been verified against the packing list and instruments have been inspected for mechanical and electrical
operation.
Starting the Instrument
This section describes installation instructions and verification tests.
Applying Power
Place the instrument on the intended workbench and connect the appropriate DC power supply to the
receptacle on the rear of the unit. Make sure you use the included DC power supply.
Using other supplies may lead to malfunction and damage of
the Instrument
.
Press the line on/off switch on the rear panel. If available, the front panel display will illuminate. The
instrument will initialize and momentarily display the model number, firmware revision and product serial
number. The display will then switch to the factory default display setting, showing preset frequency and
