Analytik Jena CyBio Well vario OL3381-25-300, Operating Manual

Page: 35 / 164

CyBio
®
Well vario Release: 2017 19
Safety Notes
3.10.2 Compressed Air Supply (Only For Capillary Head)

Compressed air may prove a source of danger if operators are not familiar with
the way it must be handled. For this reason, the system may not be operated by
anyone other than qualified personnel.

Apply compressed air only in operating conditions as described herein.

Make sure that the maximum allowed pressure is not exceeded.

Ensure that the counterlocking nut is properly tightened on completion of oper-
ating pressure setting.

Turn compressed air supply off for idle system periods and drain the inner system
space.

Do not use compressed air that contains chemicals, synthetic oils with organic
solvents or etching gases, etc., because such impurities may result in malopera-
tion of the system.

On failure to remove condensate from air filters and microfilters, there may be
outflow of condensate on the output side and consequential malfunction of the
compressed air duct. Always track the condensate reservoir filling level for this
reason.

Work for preventive maintenance or replacement of compressed air duct compo-
nents may only be performed by persons properly trained in the handling of com-
pressed air.
3.10.3 Explosion Proofness, Fire Prevention

The CyBio
®
Well vario must not be operated in an explosive environment or using
explosive substances.

Smoking or using open fire are forbidden inside of the operating room!

Operating personnel must be duly informed about the locations and the proper
handling of fire-extinguishing equipment in the operating room.
3.10.4 Electrical

Working on electrical and electronic parts of the system and its components may
only be carried out by a suitably qualified electrician according to latest binding
electrical regulations.

Never start up the device if cables are damaged (e.g. cuts in cabling, worn or
chafed places)!

Observe prescribed maintenance intervals (
→
refer to page 116 ).

The main power plug includes a ground (PE) contact that may only be connected
to a to a socket with ground contact. The grounding conductor may not be inter-
rupted (e.g. through the use of a voltage regulating transformer). Do not use
extension cables without a grounding conductor!

Power cabling must be installed in a workmanlike manner!

To detach this cable from the mains socket, always hold it by the plug.

Do not contact or hold the line plug with wet hands!

Under no circumstances may system shielding be removed. There is life-threaten-
ing danger due to electrical shock if shielding parts are removed!