ADM & Sub Aspida
User Manual
Int. Approved
Document ref: PSA-811-22
March 2020
Page 16 of 45
Copyright © 2017 Analox Ltd. All Rights Reserved.
Commercial in Confidence
6
Operation
6.1
Button functions
The Analox Aspida has three buttons that are used as follows:
Button
Function
•
Power on/off
•
Confirm
•
Select button
•
Show device menu
•
Cycle through options
•
Cancel
•
Return to main screen
6.2
Switching the device on/off
To switch the Analox
Aspida on, press the
button.
After a few seconds, the main gas display screen will be shown. If multiple usernames are
registered to the device, then the username selection screen will be shown instead. See the
section ‘
for further instructions.
On start-up, the sensors have a short warm-up period. Live gas values will not be displayed until
the sensors have completed their warm-up. Typically, for oxygen, the warm-up takes 15 seconds
and for carbon dioxide, the warm-up takes 30 seconds. Sensor warm-up will be shown on the
display.
To switch off the device, from the main display press and hold the button until the screen goes
blank then release the button.
To return to the main display from the menu system, press and release the button as required
to exit the menus.
NOTE:
THE DEVICE CANNOT BE TURNED OFF WHEN POWERED FROM
USB.
Summary of Contents for ADM Aspida
Page 2: ......
