ADM & Sub Aspida
User Manual
Int. Approved
Document ref: PSA-811-22
March 2020
Page 13 of 45
Copyright © 2017 Analox Ltd. All Rights Reserved.
Commercial in Confidence
4.4
Battery installation
The Analox Sub Aspida is powered by a pair of standard AA batteries. The device can be powered
using the NiMH re-chargeable batteries included in the product package or using a pair of standard
AA type non-rechargeable batteries.
The Analox ADM Aspida is powered by a universal mains adaptor, 90-264VAC to 9VDC, with a
2.1mm x 5.5mm x 12mm DC jack plug
–
centre pin positive. Battery backup is available as an
optional extra, this can be supplied by Analox, see spares and accessories list at section 7.1
To gain access to the battery compartment, undo the screw in the centre of the battery cover on
the rear of the device and lift the cover off. Before removing batteries from the device, ensure that
it is switched off and that the mains charger and USB cable are disconnected.
Figure 2
Battery compartment
1)
Battery compartment access screw
2)
Sensor compartment access screws
3)
Battery compartments
WARNING: CARE SHOULD BE TAKEN WHEN INSERTING BATTERIES,
PAYING PARTICULAR ATTENTION TO THE ORIENTATION OF
EACH BATTERY. MARKINGS ON THE INSIDE OF THE BATTERY
COMPARTMENT INDICATE THE CORRECT BATTERY
ORIENTATION. INCORRECT ORIENTATION OF THE
BATTERIES MAY RESULT IN DAMAGE TO THE DEVICE.
BATTERIES SHOULD BE INSERTED BY HAND WITHOUT USE
OF TOOLS USING REASONABLE FORCE ONLY.
Summary of Contents for ADM Aspida
Page 2: ......
