Picturall Quad Mark II
Ref. MSQ04-MkII
QUICK START GUIDE
Thank you for choosing
Analog Way
and the
Picturall Quad Mark II
. By following these simple steps, you will
be able to set up and use your Powerful media server within minutes. Discover the
Picturall Quad Mark II
capabilities and intuitive interface while commanding top-notch presentations and unleash your creativity
for a new experience in show and event management.
• 1 x
Picturall Quad Mark II (MSQ04-MkII)
• 1 x Power supply cord (or 2x with optional redundant PSU)
• 1 x Ethernet cross cable (for device control)
• 1 x USB memory stick containing software and technical documentation
• 1 x Rackmount kit
• 1 x User manual (PDF version)*
• 1 x Quick start guide*
* User Manual and quick start guide are also available on
www.analogway.com
Go on our website to register your product(s)
and be notified about new firmware versions:
http://bit.ly/AW-Register
WHAT’S IN THE BOX
QUICK SETUP & OPERATION
CAUTION!
Damage caused by improper
rack mounting will not be cove
-
red under warranty.
Register
your product
Connecting with the Web Configurator
The
Picturall Quad Mark II
uses standard ethernet
LAN networking. To access the Web Configurator,
connect a computer to the
Picturall Quad Mark II
using the Ethernet cable. Then on your computer,
open an internet browser and enter the IP address
of the
Picturall Quad Mark II
(displayed on the
front panel screen).
The connection should start.
Often, computers are set to DHCP client (automatic
IP detection) mode. You may need to change the
IP address configuration on your computer before
you can connect. These settings are found in the
properties for your LAN network adaptor, and vary
by operating system.
The default IP address on the
Picturall Quad Mark II
is
192.168.2.140
with a netmask of
255.255.255.0.
Therefore, you can assign your computer a static
IP address of
192.168.2.100
and a netmask of
255.255.255.0
and should be able to connect.
If the connection is not starting:
• Make sure the computer IP address is on the
same network and subnet as the
Picturall Quad
Mark II
.
• Make sure that no devices have the same IP
address (prevent IP conflicts)
• Make sure the network cable is CAT5 or higher.
• For more information, please see the user manual
or contact your local technical support.
Once successfully connected, the Web Configurator
is displayed automatically.
