21
USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
4.6
Power on and off
Start the LivePremier
To start the LivePremier unit safely and correctly:
1.
Connect all inputs and outputs.
2.
Connect the power cables to the unit and then plug them into a mains socket.
3.
Press the power button on the front panel.
Power off
Tip
: - The following procedure is the recommended method to safely turn off the LivePremier unit.
- Saving the configuration before powering off is not necessary. The unit saves the current configuration in real time.
4.6.2.1
Power off from the Front panel
To turn off the LivePremier unit, press the Power button then press the Enter button to confirm.
4.6.2.2
Power off from the WebRCS
Click
in the WebRCS top bar, then click
Standby
and confirm.
Forced shutdown
Caution
: Use forced shutdown only if the unit has crashed. Using forced shutdown regularly is not recommended.
If the LivePremier unit crashed, turn off the power by Forced shutdown.
-
Press and hold the Power button on the front panel until shutdown.
4.7
Precautions when mounting a LivePremier unit
Warning
: - For safety reasons, it is recommended to earth the unit. Use an earth cable (not provided) to earth a screw of
the unit’s chassis.
- Follow these precautions to avoid risks for products and users.
- Do not put a magnetic plate in contact with the upper part of the unit as it may block the fans of the unit.
When mounting the LivePremier unit, ensure proper air flow and consider the following points on safe use.
-
Always use the handles built on the sides of the chassis for easy mounting into any standard rack or
flight case.
-
Remove the front and back panels of the flight case during operation to provide sufficient air flow
through the unit and prevent overheating.
-
Place the unit preferably in a cool and dry environment.
-
The fans inside the unit expel the heat through the front and rear panels. Therefore, it is crucial that
both the front and the rear are unobstructed at all times. A minimum of 50 cm (20 in.) of clear space
at the front and rear of the unit is recommended.
-
Do not block the ventilation.
-
Do not place any fluid above or near the unit.
-
Do not place any magnetic equipment on or near the unit.
-
Do not apply any pressure against the chassis or the connectors.
