Evaluation Board User Guide
UG-XXX
REFERENCE OPTIONS
The EVAL-AD7124-8SDZ includes an external 2.5 V reference
(the ADR4525) and an internal 2.5 V reference. The default
operation is to use the external reference input, which is set to
accept the 2.5 V ADR4525 on the evaluation board.
The reference used for a conversion is selected by choosing the
reference in the Configx registers associated with Setup 0 to
Setup 15.
Switch between using the internal reference and external reference
by accessing the AD7124-8 register map via the evaluation soft-
ware. Figure 2 shows how to select the reference source for
Setup 0 to Setup 15. Figure 3 shows the ADC_Control register
setting that enables the internal reference.
Figure 2. Selecting the Reference Source
Figure 3. Turning On the Internal 2.5 V Reference
EVALUATION BOARD SETUP PROCEDURES
After following the instructions in the Software Installation
Procedures section, set up the evaluation and SDP boards as
detailed in this section.
Warning
The evaluation software and drivers must be installed before con-
necting the evaluation board and
board to
the USB port of the PC to ensure that the evaluation system is
correctly recognized when it is connected to the PC.
Configuring the Evaluation and SDP Boards
1.
board to Connector A or
board. Screw
the two boards together using the plastic screw-washer set
included in the evaluation board kit to ensure that the
boards are connected firmly together.
2.
Connect the power supplies to the EVAL-AD7124-8SDZ
board. The EVAL-AD7124-8SDZ board, by default, uses
the wall wart (dc plug) supply that accompanies the
evaluation kit. Connect this supply to J5 on the EVAL-
AD7124-8SDZ board. (For more information about the
required connections and available options, refer to the
Power Supplies section.)
3.
board to the PC using the
supplied USB cable.
Rev. PrA | Page 7 of 36
Summary of Contents for UG Series
