Analog Devices EZ-KIT Lite ADSP-BF533, Manual

Page: 27 / 108

ADSP-BF533 EZ-KIT Lite Evaluation System Manual 1-5
Getting Started
Installing and Registering Vi+ License
Vi+ and EZ-KIT Lites are licensed products. You may run only
one copy of the software for each license purchased. Once a new copy of
the Vi+ or EZ-KIT Lite software is installed on your PC, you
must install, register, and validate your licence.
The Vi+ 3.5 Installation Quick Reference Card included in your
package will guide you through the licence installation and registration
process (refer to Tasks 1, 2, and 3).
Setting Up EZ-KIT Lite Hardware
The ADSP-BF533 EZ-KIT Lite board is designed to run outside your per-
sonal computer as a stand-alone unit. You do not have to open your
computer case.
To connect the EZ-KIT Lite board:
1. Remove the EZ-KIT Lite board from the package. Be careful when
handling the board to avoid the discharge of static electricity,
which may damage some components.
2. Figure 1-1 shows the default jumper settings, DIP switch, connec-
tor locations, and LEDs used in installation. Confirm that your
board is set up in the default configuration before continuing.
The EZ-KIT Lite evaluation system contains ESD
(electrostatic discharge) sensitive devices. Electrostatic
charges readily accumulate on the human body and
equipment and can discharge without detection. Per-
manent damage may occur on devices subjected to
high-energy discharges. Proper ESD precautions are
recommended to avoid performance degradation or
loss of functionality. Store unused EZ-KIT Lite boards
in the protective shipping package.