Analog Devices EVAL-ADM1075MEBZ, User Manual

Page: 7 / 17

EVAL-ADM1075MEBZ User Guide UG-548
Rev. A | Page 7 of 16
EVALUATION BOARD HARDWARE
SWITCH, JUMPER, AND LED FUNCTIONS
EVAL-ADM1075MEBZ
Table 2. Connector Functions
Connector Description
RTNIN, −48VIN Hot swap line voltage inputs that also power the board components. The input voltage ranges from −30 V to −75 V.
−48VOUT Hot swap line voltage output.
J3 8-way connector; use a Micro-MaTch ribbon cable to connect to an EVAL-ADM1075-ISOZ isolation board.
Table 3. Switch Functions
Switch Description
RESTART Push-button switch to trigger a shutdown that lasts for 10 sec.
Table 4. LED Functions
LED Description
D_PWRGD PWRGD, active low; green.
Table 5. On-Board ICs
IC Description
U1 ADM1075 main IC.
Table 6. Retry Configuration
Bill of Materials Component
Retry Scheme R-7RTY R-1-10S R-7-10S
No Retries (Latch Off) Not populated Not populated Not populated
Seven Retries, Then Latch Off (Default) 0 Ω Not populated Not populated
One Retry Every 10 sec Not populated 0 Ω Not populated
Seven Retries Every 10 sec Not populated Not populated 0 Ω