EVAL-AD7175-2SDZ User Guide
UG-AD7175-2
Channel Configuration Overview (6)
This section shows the channel configuration including setup
and analog inputs. This allows for a quick check of how the
ADC is setup.
Status Bar (7)
This section display status updates such as
Analysis Completed
and
Reset Completed
during software use as well as the
software version and busy indicator.
Figure 8. Waveform Tab of the
Evaluation Board Software
WAVEFORM TAB (8)
Analysis Channel (9)
The Noise Analysis section and Histogram Graph shows the
analysis of the channel selected via this Analysis Channel
control.
Samples (10 & 11)
The
Samples
(10) numeric control and batch control (11) set
the number of samples gathered per batch and whether only a
single batch of multiple batches of samples are gathered. This is
unrelated to the ADC mode. You can capture a defined sample
set, or continuously gather batches of samples. In both cases,
the number of samples set in the
Samples
(10) numeric input
dictates the number of samples.
Sample (12)
This starts gathering ADC results. Results appear in the
Waveform Graph (13)
Waveform Graph and Controls(13 & 14)
The data waveform shows each successive sample of the ADC
output. The control toolbar (14) in the graph allows you to
zoom in on the data. Change the scales on the graph by typing
values into the x-axis and y-axis.
Channel Selection (15)
This control allows you to choose which channels display on the
data waveform. It also shows the analog inputs for that channel
labeled next to the on and off controls. These controls only
Rev. Pr.C | Page 9 of 12
