Boot Mode Select (
S1
)
The Boot Mode selection switch selects between the different boot modes of the processor. The
Boot Mode Switch
table shows the available boot mode settings. By default, the processor boots from SPI2 master boot which uses the
on-board SPI flash memory.
Table 3-6:
Boot Mode Switch
Position
Processor Boot Mode
0
No Boot
1
SPI Master Boot (Default)
2
SPI Slave Boot
3
UART Boot
4
Link Port Boot
5
OSPI Master Boot
6
eMMC Boot
7
Reserved
Reset Pushbutton (
S2
)
The reset pushbutton resets the ADSP-SC598 processor. The reset signal also is connected to the expansion connec-
tors via the
SYS_HWRST
is used to indicate when the board is in reset.
Jumpers
This section describes functionality of the configuration jumpers. The
Switch/Jumper Locations
figure shows the
jumper locations.
Power (
JP1
)
The Power jumper selects the input power source to the EV-SC598-SOM. Pin 1-2 selects power input from the P1
USB Port and Pin 2-3 selects Power from the SoM Interface Connection. When using the EV-SOMCRR-EZKIT or
other plug in carrier board, use Jumper setting Pin 2-3.
LEDs
This section describes the on-board LEDs. The
LED Locations
figure shows the LED locations.
Switches
3–10
EV-SC598-SOM
®
Manual
Summary of Contents for EV-SC598-SOM
Page 33: ...EV SC598 SOM Manual 17...
