Analog Devices ADZS-BF707-BLIP2, Manual

Page: 22 / 60

BLIP2 Board Session Startup
1-4 ADZS-BF707-BLIP2 Board Evaluation System Manual
Step 2: Providing power to the BLIP2 board.
1. Plug one side of the USB Micro-B to Standard-A cable into the
USB connector
P4
on the BLIP2 board. Plug the other side into a
USB port of the PC. If there lacks a USB port to supply power to
BLIP2 board, follow the instructions in the next two steps.
2. Plug the jack-end of the assembled power adaptor into the power
connector (
REFDES
)
P5
(labeled
5V
) on the BLIP2 board.
3. Plug the other side of the power adaptor into a power outlet.
BLIP2 Board Session Startup
It is assumed that the CrossCore Embedded Studio software is installed
and running on your PC.

Note: If you connect the board or emulator first (before installing
CCES) to the PC, the Windows driver wizard may not find the
board drivers.
1. Navigate to the CCES environment through the Start menu.
Note that CCES is not connected to the target board.
2. Use the Debug Configurations wizard to connect to the BLIP2
board.
If a debug configuration exists already, select the appropriate
configuration and click
Debug . Go to step 8.