Analog Devices ADV8005, Hardware Reference Manual

Page: 107 / 317

ADV8005 Hardware Reference Manual UG-707
60/24 Hz timing in the table.
Table 20: PVSP Supported Output Video Timing and VID
Video Timing VID
CEA
640x480p60 1
720x480p60 2 or 3 or 14 or 15 or 35 or 36
720(1440)x240p60 8 or 9
720(2880)x240p60 12 or 13
1280x720p60 4
1920x1080p 16
720x576p50 17 or 18 or 29 or 30 or 37 or 38
1280x720p50 19
720x288p50 23 or 24 or 27 or 28
1920x1080p50 31
1920x1080p24 32
1920x1080p25 33
1920x1080p30 34
720p100 41
576p100 42 or 43
720p120 47
480p120 48 or 49
576p200 52 or 53
480p240 56 or 57
4kx2k 30 Hz 112
4kx2k 25 Hz 113
4kx2k 24 Hz 114
4kx2k 24 Hz SMPTE 115
VESA
timing
VGA 200
SVGA 201
XGA 202
WXGA 203
SXGA 204
WXGA-2 205
UXGA 206
WXGA-3 207
WUXGA 208
If overscan, crop or album mode is being used, the required blocks must be configured manually by enabling the corresponding enable bits, such
as
pvsp_vim_crop_enable , to enable the VIM crop block.
3.2.1.2. Customized Input/Output Video Format Configuration
If the input timing is not in the PVSP input format table, customized input format needs to be set manually.
If the input resolution has a variation with regard to standard timing (for example, if
pvsp_autocfg_input_vid[7:0] is set to 2, which indicates
the input resolution is 720x480, but the actual resolution is 718x478), the user can manually set pvsp_autocfg_input_vid[7:0] to 0 and set the
input resolution through the following three registers.
pvsp_man_input_res , Primary VSP Map, Address 0xE884[5]
This bit is used to enable the manual configuration of the input resolution.
Function
pvsp_man_input_res Description
0 (default) Disable manual configuration of input resolution
1 Enable manual configuration of input resolution
Rev. A | Page 107 of 317