EVAL-ADuCM350EBZ User Guide
UG-668
One
Technology Way • P.O. Box 9106 • Norwood, MA 02062-9106, U.S.A. • Tel: 781.329.4700 • Fax: 781.461.3113 • www.analog.com
Evaluating the
ADuCM350
16-Bit, Precision, Low Power Meter-on-a-Chip
PLEASE SEE THE LAST PAGE FOR AN IMPORTANT
WARNING AND LEGAL TERMS AND CONDITIONS.
Rev. A | Page 1 of 28
FEATURES
ADuCM350
motherboard
Selection of daughter boards for analog front end and
platform validation
3 power supply options: 2.5 V to 3.6 V from an external
power supply, 5 V from interface/emulator board, or
CR2032 battery connection
Interface options
UART and serial wire through 8-pin J-Link OB connector
Trace capability
Power indicator/general-purpose LEDs
Reset, download, and external interrupt push-buttons
Supercapacitor and thermistor capability
USB connectivity
8-pin connector to the interface/emulator board
Access to
ADuCM350
platform pins through Digital Header 1,
Digital Header2, and CapTouch header
32.768 kHz external crystal and 16 MHz external crystal
EVALUATION KIT CONTENTS
EVAL-ADuCM350EBZ
board
USB-SWD/UART-EMUZ, also known as J-Link OB emulator
AFE daughter boards:
ADuCM350
switch mux configuration
board,
ADuCM350
4-wire bio Configuration 2 board
ADuCM350
breakout board
ADuCM350
GPIO test header board
USB cable
ADDITIONAL EQUIPMENT AND SOFTWARE NEEDED
Evaluation software for the
ADuCM350
(download from the
ADuCM350 design resources
page)
Extra peripheral boards available for order:
Ev-ADuCM350AUDZ
,
Ev-ADuCM350DISZ
See the
ADuCM350 design resources
page for more details
SYSTEM REQUIREMENTS
Minimum requirement to run examples and applications
PC with USB 2.0 controller connection and 1 free COM port
Windows XP SP3 or later, Windows Vista, or Windows 7 or later
ONLINE RESOURCES
Documents Needed
ADuCM350
data sheet
ADuCM350
hardware reference manual
AN-1262
,
AN-1263
,
AN-1271
,
AN-1281
,
AN-1286
,
AN-1293
,
AN-1302
application notes
ADuCM350
software development kit quick start guide
(
UG-677
)
Required Software
ADuCM350
software development kit (firmware/debug
environment)
IAR Embedded Workbench for ARM (from Version 7.10+)
ADuCM350
evaluation kit software platform (GUI software)
Design and Integration Files
Schematics, layout files, bill of materials
TYPICAL SETUP
Figure 1. Typical Setup (USB-SWD/UART-EMUZ on Left and
EVAL-ADuCM350EBZ
on Right)
PERIPHERALS
CONNECTOR
2
PERIPHERALS
CONNECTOR
1
CapTouch
CONNECTOR
USB
CR2032
EXTERNAL
SUPPLY SUPPLY
TRACE
USB-SWD/UART-EMUZ
AFE
DAUGHTER
BOARD
12104-
001
