Jumpers
2-20
ADSP-BF518F EZ-Board Evaluation System Manual
VDDMEM Power Jumper (P10)
The VDDMEM power jumper (
P10
) is used to measure the voltage and
current supplied to the memory interface of the processor. By default,
P10
is
ON
, and the power flows through the two-pin IDC header. To measure
power, remove
P10
and measure voltage across the 0.1 ohm resistor. Once
voltage is measured, power can be calculated. For more information, refer
to
“Power Measurements” on page 1-24
.
VDDFLASH Power Jumper (P11)
The VDDFLASH power jumper (
P11
) is used to measure the flash voltage
and current supplied to the processor core.
P11
is
ON
by default, and the
power flows through the two-pin IDC header. To measure power, remove
P11
and measure voltage across the 0.1 ohm resistor. Once voltage is mea-
sured, power can be calculated. For more information, refer to
