The proper power up sequence is:
1. JTAG Emulator
2. ADSP-21065L EZ-KIT Lite board
To remove power, reverse the order.
Figure 5-3 JTAG Connector With Jumpers Installed
Figure 5-3 shows the locations of the configuration jumpers on the EZ-KIT Lite board
and which pin on the jumpers is the GND pin. These jumpers should be checked before
using the board to ensure proper operation. Each of the jumper selection blocks are
described in the following sections.
5.5 Jumpers
5.5.1 Boot Mode Selection Jumper
The jumper (JP6) controls the behavior of the ADSP-21065L processor when the system
is reset (from power up or when the RESET button is used). When the jumper is not
connected to GND, or is removed, the processor boots from the EPROM. If the jumper
is connected to GND, the processor attempts to boot from its host interface (through the
expansion port).
Table 5-3
Boot Mode Selection
JP6 Description
GND HOST
boot
Other
EPROM boot (factory default)
45
www.BDTIC.com/ADI
