Figure 4-2 Target Message
4. Press the Reset button on the evaluation board.
All the LEDs light up and after a brief delay (<2 seconds) all of the LEDs turn off except for the
FLAG9 and power LEDs. Make sure that the LEDs turn off (except for the FLAG9 and power
LEDs) before you click OK.
During this delay, the POST tests run which verify operation of RAM, the AD1819, the UART,
and the EPROM. After the LEDs go dark, a message box opens with the message shown in
Figure 4-3.
Figure 4-3
Target Communications Status Message Box
5.
Click
OK.
The initialization completes and the disassembly window opens. The code in the disassembly
window is the EZ-KIT Lite monitor program.
4.3 Debugger Operation with the ADSP-21065L EZ-KIT Lite
The
Vi+ Debugger Guide & Reference
and the
Debugger Tutorial (for ADSP-2106x Family
DSPs)
contains most of the information you need to operate the Vi+ Debugger with your EZ-KIT
Lite evaluation board. Because the manual was written using a simulator as a target, there are some
differences and restrictions in debugger operation that are described in this section.
4.3.1 Loading Programs
Because you are loading programs into a hardware target, the load process takes a bit more time
then loading in the simulator. Wait for the Load Complete message in the Output window before
you attempt any debug activities.
34
www.BDTIC.com/ADI
