AMX TPI-PRO-4, Operation/Reference Manual

Page: 104 / 218

NetLinx Programming
98 TPI-PRO/DVI (Total Presentation Interface)
Page Commands (Cont.)
PPOF
Deactivate a
specific pop-up
page on either a
specified page or
the current page.
If the pop-up page is part of a group, the whole group is deactivated. This command works
in the same way as the ’Hide Popup’ command in TPDesign4.
Note: If the page name is empty, the current page is used (see example 2).
Syntax:
"'PPOF-<popup page name>;<page name>'"
Variables:
• popup page name = 1 - 50 ASCII characters. Name of the pop-up page.
• page name = 1 - 50 ASCII characters. Name of the page on which the pop-up is
displayed.
Example:
SEND_COMMAND Panel,"'PPOF-Popup1;Main'"
Deactivates the pop-up page ’Popup1’ on the Main page.
Example 2:
SEND_COMMAND Panel,"'PPOF-Popup1'"
Deactivates the pop-up page ’Popup1’ on the current page.
PPOG
Toggle a specific
pop-up page on
either a specified
page or the
current page.
If the page name is empty, the current page is used (see example 2). Toggling refers to the
activating/deactivating (On/Off) of a pop-up page. This command works in the same way
as the ’Toggle Popup’ command in TPDesign4.
Syntax:
"'PPOG-<popup page name>;<page name>'"
Variables:
• popup page name = 1 - 50 ASCII characters. Name of the pop-up page.
• page name = 1 - 50 ASCII characters. Name of the page on which the pop-up is
displayed.
Example:
SEND_COMMAND Panel,"'PPOG-Popup1;Main'"
Toggles the pop-up page ’Popup1’ on the Main page from one state to another (On/Off).
Example 2:
SEND_COMMAND Panel,"'PPOG-Popup1'"
Toggles the pop-up page ’Popup1’ on the current page from one state to another (On/Off).
PPON
Activate a specific
pop-up page to
launch on either a
specified page or
the current page.
If the pop-up page is already On, do not re-draw it. This command works in the same way
as the ’Show Popup’ command in TPDesign4.
Note: If the page name is empty, the current page is used (see example 2).
Syntax:
"'PPON-<popup page name>;<page name>'"
Variables:
• popup page name = 1 - 50 ASCII characters. Name of the pop-up page.
• page name = 1 - 50 ASCII characters. Name of the page on which the pop-up is
displayed.
Example:
SEND_COMMAND Panel,"'PPON-Popup1; Main'"
Activates the pop-up page ’Popup1’ on the Main page.
Example 2:
SEND_COMMAND Panel,"'PPON-Popup1'"
Activates the pop-up page ’Popup1’ on the current page.