AMX TDS - Terrestrial/Satellite (Standard Definition)
24
AMX TDS (Television Delivery System)
Network Port Pinouts and Signals
The following table lists the pinouts, signals, and pairing for the NETWORK port.
FIG. 34 diagrams the pinouts and signals for the Network RJ45 connector and cable. Note that while 568B
termination is shown in the figure, 568A can also be used, as long as both ends are terminated the same way.
Ethernet LEDs
Default IP Address
By default, DTV-TX Transmitters are set to
DHCP
.
RJ45 Network Port Pinouts and Signals
Pin
Signals
Connections
Pairing
Color
1
TX +
1 --------- 1
1 --------- 2
Orange-White
2
TX -
2 --------- 2
Orange
3
RX +
3 --------- 3
3 --------- 6
Green-White
4
no connection
4 --------- 4
Blue
5
no connection
5 --------- 5
Blue-White
6
RX -
6 --------- 6
Green
7
no connection
7 --------- 7
Brown-White
8
no connection
8 --------- 8
Brown
FIG. 34
RJ45 wiring diagram
Consult the Network Administrator for correct cabling from the DTV-TX Transmitter
onto the network.
For remote connectivity, the Firewall may have to be configured to open port 2008 for
remote connectivity over UDP.
Ports 5000 and 5001 are required for the Transmitters as well as any ports used for
the TDS Multicast stream.
Ports 5002 and 5003 are fixed as the multicast stream output ports.
FIG. 35
Ethernet LEDs
SPD
- Speed LED
connection speed is 100 Mbps
and turns Off when speed is
lights (yellow) when the
L/A
- Link/Activity LED
lights (green) when the
Ethernet cables are
connected and terminated
10 Mbps.
correctly.
Summary of Contents for TDS
Page 8: ...vi AMX TDS Television Delivery System Table of Contents ...
Page 86: ...Digital TV Configuration Manager 78 AMX TDS Television Delivery System ...
Page 90: ...Serial Commands 82 AMX TDS Television Delivery System ...
Page 105: ...FAQs and Recommendations 97 AMX TDS Television Delivery System ...
