Interface Configuration
78
Instruction Manual - NXA-ENET8-POE+
Perform these steps to display LACP settings and status for the local side:
1.
Click
Interface
>
Trunk
>
Dynamic
.
2.
Select
Configure Aggregation Port
from the Step list.
3.
Select
Show Information
from the Action list.
4.
Click
Internal
.
5.
Select a group member from the Port list.
Displaying LACP Settings and Status for the Remote Side
Use the Interface > Trunk > Dynamic (Configure Aggregation Port - Show Information - Neighbors) page to display the
configuration settings and operational state for the remote side of a link aggregation.
The following table lists the options on this page:
FIG. 75
Displaying LACP Port Internal Information
LACP Remote Device Configuration Information
Partner Admin System ID
LAG partner's system ID assigned by the user.
Partner Oper System ID
LAG partner's system ID assigned by the LACP protocol.
Partner Admin Port Number
Current administrative value of the port number for the protocol Partner.
Partner Oper Port Number
Operational port number assigned to this aggregation port by the port's protocol partner.
Port Admin Priority
Current administrative value of the port priority for the protocol partner.
Port Oper Priority
Priority value assigned to this aggregation port by the partner.
Admin Key
Current administrative value of the Key for the protocol partner.
Oper Key
Current operational value of the Key for the protocol partner.
Admin State
Administrative values of the partner's state parameters. (See preceding table.)
Oper State
Operational values of the partner's state parameters. (See preceding table.)