Interface Configuration
62
Instruction Manual - NXA-ENET8-POE+
Perform these steps to configure port connection parameters:
1.
Click
Interface
>
Port
>
General
.
2.
Select
Configure by Port List
from the Action List.
3.
Modify the required interface settings.
4.
Click
Apply
.
Configuring by Port Range
Use the Interface > Port > General (Configure by Port Range) page to enable/ disable an interface, set auto-negotiation and the
interface capabilities to advertise, or manually fix the speed, duplex mode, and flow control.
Except for the trap command, refer to the
section on page 61 for more information on command usage and
a description of the options on the page.
Perform these steps to configure port connection parameters:
1.
Click
Interface
>
Port
>
General
.
2.
Select
Configure by Port Range
from the Action List.
3.
Enter a range of ports to which your configuration changes apply.
4.
Modify the required interface settings.
5.
Click
Apply
.
Flow Control
Allows automatic or manual selection of flow control. (Default: Enabled)
Link Up Link Down
Issues a notification message whenever a port link is established or broken. (Default: Disabled)
FIG. 51
Configuring Connections by Port List
FIG. 52
Configuring Connections by Port Range
Interface - Port (General) Options