Basic Administration Protocols
194
Instruction Manual - NXA-ENET8-POE+
Configuring LLDP Interface Civic-Address
Use the Administration > LLDP (Configure Interface - Add CA-Type) page to specify the physical location of the device attached to
an interface.
Command Usage
Use the Civic Address type (CA-Type) to advertise the physical location of the device attached to an interface, including
items such as the city, street number, building and room information. The address location is specified as a type and value
pair, with the civic address type defined in RFC 4776. The following table describes some of the CA type numbers and
provides examples.
Any number of CA type and value pairs can be specified for the civic address location, as long as the total does not exceed
250 characters.
The following table lists the options on this page:
Perform these steps to specify the physical location of the attached device:
1.
Click
Administration
>
LLDP
.
2.
Select
Configure Interface
from the Step list.
3.
Select
Add CA-Type
from the Action list.
4.
Select an interface from the Port or Trunk list.
5.
Specify a CA-Type and CA-Value pair.
6.
Click
Apply
.
LLDP MED Location CA Types
CA Type
Description
CA Value Example
1
National subdivisions (state,
canton, province)
California
2
County, parish
Orange
3
City, township
Irvine
4
City division, borough, city district
West Irvine
5
Neighborhood, block
Riverside
6
Group of streets below the
neighborhood level
Exchange
18
Street suffix or type
Avenue
19
House Number
320
20
House number suffix
A
21
Landmark or vanity address
Tech Center
26
Unit (apartment, suite)
Apt519
27
Floor
5
28
Room
509B
Administration - LLDP Options
CA-Type
Descriptor of the data civic address value. (Range: 0-255)
CA-Value
Description of a location. (Range: 1-32 characters)
FIG. 223
Configuring the Civic Address for an LLDP Interface