Security Measures
165
Instruction Manual - NXA-ENET8-POE+
Perform these steps to add rules to an ARP ACL:
1.
Click
Security
>
ACL
.
2.
Select
Configure ACL
from the Step list.
3.
Select
Add Rule
from the Action list.
4.
Select
ARP
from the Type list.
5.
Select the name of an ACL from the Name list.
6.
Specify the action (i.e., Permit or Deny).
7.
Select the packet type (Request, Response, All).
8.
Select the address type (Any, Host, or IP). If you select Host, enter a specific address (e.g., 11-22-33-44-55-66). If you select
IP, enter a base address and a hexadecimal bit mask for an address range.
9.
Enable logging if required.
10. Click
Apply
.
Binding a Port to an Access Control List
After configuring ACLs, use the Security > ACL (Configure Interface - Configure) page to bind the ports that need to filter traffic to
the appropriate ACLs.
The following table lists the options on this page:
FIG. 193
Configuring an ARP ACL
Security - ACL Options
Type
Selects the type of ACLs to bind to a port.
Port
Port identifier (Range: 1-10/26/28/52)
ACL
ACL used for ingress packets.
Time Range
Name of a time range.
Counter
Enables counter for ACL statistics.