Epica DGX 144 HD-15 RGBHV Input Board
55
Epica DGX 144 Instruction Manual
Determining Resolution and Refresh Rate for Source PC
If you do not know the video card resolution and refresh rate on the Source PC, use the directions below
to find out before attempting to adjust the video display. Because video display settings cannot be
recalled, we strongly recommend writing this information down.
To determine video card resolution/refresh settings on Windows
®
operating systems:
1.
Minimize all applications on the Source PC.
2.
Right click on the desktop.
3.
Select Properties from the shortcut menu.
4.
Select the Settings tab in the Display Properties dialog box.
5.
Check the Screen resolution setting; write it down.
6.
Click Advanced.
7.
Select the Monitor tab.
8.
Check the Screen refresh rate (frequency, which is expressed in Hertz); write it down.
If this setting is not located under the Monitor tab, try selecting other available tabs.
9.
Click Cancel on each dialog box to exit.
Important:
If all of the device EDIDs do not fall within the default resolution parameters provided
(check “Specifications” on page 52), see “Appendix A
–
EDID Programmer” on page 63 before
adjusting the video with the DG_HD15 Wizard.
Adjusting the Video with the DG_HD15 Wizard
Before starting the adjustment procedure:
Install the DG_HD15 Wizard on the Control PC. (We recommend uninstalling any versions
of BoardConfig software prior to v1.4.0 first.)
Connect the Control PC via a null modem cable to the serial port on the Epica DGX 144.
Transfer the test image files from the Control PC to the Source PC.
Determine the resolution and refresh rate of the Source PC (see instructions above).
Adjustment Tips:
Be sure that the source device that is sending the signal to the display monitor (or device)
has a sharp picture before you start.
The Destination Monitor controls may need adjusting during the following procedure.
For some 640x480 displays, selecting an 800x600 resolution from the wizard may work best.
To adjust the video display using the DG_HD15 Wizard:
1.
Route the signal from the Source PC to the Destination Monitor.
Summary of Contents for Epica DGX 144
