Revised: 12/16/2015
N:\AmTryke\Manuals and Instructions\New Manuals\Manual Docs and Pdf\JT2000
1.
Loosen the lock nut on the brake lever by turning it to the left
(counterclockwise).
2.
Loosen the Ferrell by turning it to the left two complete turns.
3.
Tighten the lock nut by turning it to the right (clockwise).
4.
Test the brakes to see if they hold
if they do then you are finished. If the
brakes do not hold and the bike still moves freely repeat step 1.
5.
When you are satisfied with the brakes, pull the brake lever in all the way
ten times to make sure the cable is not going to slip.
Pedals
Put a thin washer in the pedal crank arm and hand thread the right pedal
clockwise and the left pedal counterclockwise into the pedal crank arms. When
you are certain that the pedals are threaded properly, use a 15 mm wrench to
tighten securely.
Reflectors
Install the rear reflector with bracket on the rear frame (between the seat
support brackets). Use a Phillips head
screwdriver to remove the clamping
screw from the bracket. Open the clamp
and place it on the frame. Thread the
clamping screw back and tighten.
Follow the same procedure and attach
the front reflector to the steering stem
tube.
B-2 stamped
Rear reflector
Front reflector
CAUTION:
BE CAREFUL WHEN THREADING PEDALS. DO NOT
FORCE! PEDALS THREAD EASILY WHEN INSTALLED PROPERLY.
TIP: Pedal threads tighten
toward the front of bike.
