Revised: 12/16/2015
N:\AmTryke\Manuals and Instructions\New Manuals\Manual Docs and Pdf\JT2000
Frames
To attach the frames together, slide the rear frame into the main frame. Use
four large lag bolts, washers and nuts to
secure the frames (both sides). Tighten
with a 15 mm socket or wrench.
Next, install the chain from the main
hub to the rear axle sprocket. Use a pair
of needle nose pliers to snap the master
link in place.
To finish assembling the frames, pull back on the rear frame to tighten the
chain. While pulling, tighten the four nuts with a 15 mm socket or wrench.
Install the upper support Allen bolts (one on each side), washers and nuts using
a 5 mm Allen wrench and 13 mm wrench.
Seat
Start seat assembly by first attaching the seat support bracket to the rear
frame. Use two 5 mm Allen bolts and
nuts to secure it. Tighten with a 10 mm
socket or wrench, and a 5 mm Allen
wrench.
Main and rear frames attached
Allen
bolt
Lag
bolts
NOTE: Do not tighten completely
at this point.
Chain with master link
Main
hub
Master
link
Chain installed
Rear axle
sprocket
B-2 stamped
Seat support bracket
Seat
support
bracket
