Amsco 36 H, Operator'S Manual

Page: 34 / 152

5-2
P129394-068 Operator Manual Component Identification
5.1 General
Use this manual to become familiar with control locations and
functions before operating the sterilizer (refer to
Figure 5-1 and
Figure 5-3 ). The controls for this sterilizer are contained within the
control touch screen. Control touch pads appear on the screen as
needed during each operation. Available controls change as the
sterilizer steps through different operations.
5.2 Main Sterilizer and
Cycle Controls
• Main Power Disconnect Switch (refer to Figure 5-1 ) – Located
at left-hand side of the sterilizer on the main control box (when
facing operating end). Switch disconnects power to the control.
Under normal operation, this switch is left in the ON position at all
times, and accessed only when servicing the sterilizer.
• Steam Supply Valve – This is located behind the side access
panel (or within the wall enclosure), above the chamber. Refer to
Figure 5-1 . Ensure this is in the open position before trying to
operate the sterilizer.
• Water Supply Valve – This is located behind the side access
panel (or within the wall enclosure, below the chamber. Refer to
Figure 5-1 . Ensure this is in the open position before trying to
operate the sterilizer.
• Chamber Emergency Manual Exhaust Valve – Used only in
emergency situations, the valve is to be left in the closed position
for normal operation.
Figure 5-2. Location of Sterilizer Utility Controls
Main Power
Disconnect
Switch
Water Supply
Valve
Emergency Manual
Exhaust Valve
Steam Supply
Valve
NOTE: Valves and disconnect
switch behind wall enclosure
or enclosed within cabinet,
depending upon sterilizer
configuration.