Txx2672 EVM
Quick Start Guide
Rev 1.1
Figure 1: TSL2672 EVM Kit (shown)
This Quick Start Guide applies to the TSL2672 and TMD2672 EVM
kits. The illustrations in this guide show the TSL2672 EVM kit, but
the instructions apply to all of the kits.
O
UT OF THE
B
OX
Each Txx2672 EVM comes with the following components:
•
Controller board v2.1
•
Txx2672 Daughterboard
•
USB Cable with A connector and mini B connector
•
Flash Drive with Application Software and Documents
•
Quick Start Guide (not shown)
S
OFTWARE
I
NSTALLATION
Most PCs should have one or more Universal Serial Bus (USB)
ports. Install the
ams
flash drive into an unused USB port.
1.
Double-click the
Setup.exe
file on the flash drive, or
2.
Click Start -> Click Run -> Type E: setup.exe and press
Enter. IMPORTANT: Use the appropriate drive letter in
the above command to install the software. Flash Drive
will commonly be assigned the next available drive letter
for example C: hard drive D: CD-ROM E: flash drive
The Digital Light Sensor Setup Wizard will open and guide you
through the installation of the Txx2672 host software. (Figures 2
through 8). To re-install, run the setup.exe file again. To remove
the software from your computer (Figure 9), select
ams
->
Txx2672 EVM -> Uninstall Txx2672 EVM (where “xx” is replaced
with “SL” or “MD” as appropriate) or use the Windows Control
Panel.
Connect Hardware
Plug the Txx2672 Daughterboard into the Controller board. (Figure
1) Always use ESD procedures when handling the EVM.
Using the enclosed USB cable, plug the mini-B connector into the
EVM module. Using the other end of the cable, plug the USB A-
connector into a USB port on the computer.
Start Application
Click the Digital Light Sensors icon on the desktop.
Figure 2: Welcome Screen
Figure 3: Liability Disclaimer
Downloaded from
