2830A-XX SERIES THREE DIVER
PORTABLE COMMUNICATOR USER MANUAL
283XA-UM
REV 7.0
27
4.11.7
The headsets channels are now cleared of programming to the base-station.
Follow the “Base-Station Programming Instructions” to link headsets.
4.12
BASE-STATION PROGRAMMING INSTRUCTIONS
4.12.1
All “Remote” headsets to be fully charged and in the “OFF” position.
4.12.2
Remove base-station from the Amron Communicator lid. Channel selection buttons
“#1” and “#2” are located on the rear side of base-station.
4.12.3
Turn Amron Communicator power “ON”.
4.12.4
Press and hold the base-station’s programming button “#1” (to program to channel
#1) or “#2” (to program to channel #2) until the Red LED begins to flash rapidly.
This indicates that the base-station is ready to link to a Remote Headset.
4.12.5
Press the Power button on the Remote Headset and release. The Power button
should be flashing blue, and ready to be programmed.
4.12.6
Press REMOTE Headset volume DOWN arrow 3 times and release.
4.12.7
Press and HOLD the volume UP arrow until the Blue LED begins flashing, then
release. Within a few seconds, the Blue LED will turn off and then back on when
the pairing process is complete.
4.12.8
In order to program additional headsets, power down all “Remote” headsets by
holding the power button down for at least 2 seconds. The LED on the “base-
station” will go out. Press and hold the programming button of the channel you wish
to program until the Red LED begins flashing, then repeat steps 5 and 7 for each
additional headset.
Each base-station can have up to 3 remote headsets linked to each channel.
Summary of Contents for AMCOM III 2830A Series
Page 2: ......
