devices.
Compand Type
Compand standards vary between countries. Select
MULAW or ALAW for the local region.
Signaling
Select Point to point or Point to multipoint depends on
the link type between ISDN service provider and your
device.
Caller ID
Leave it blank to have the default caller ID, or enter a
caller ID that is provided by your ISDN service provider.
6.1.13Digitmap
The digitmap is for
Centrex DID
in SIP trunks. A pattern consists of digits 0-9 (including “-”), “*”, “#”,
digit set, and wildcard characters like “.”, “X”, “Z”, and “N”. in Call Route explains digit set and wildcard
characters.
Note:
The “#” in the pattern is for some PSTN saver lines that may set “#” as their dial pattern. For
most of the IP Phones, press “#” will immediately send out the dialed number.
6.1.13.1Add a Digitmap
1.
Click the
Add New
tab.
2.
Enter settings show in Table 6 -34.
3.
Click
to see the pattern in the list.
4.
Click
Add
to have newly added digitmap.
6.1.13.2Edit a Digitmap
1.
Select a digitmap ID.
2.
Edit settings show in Table 6 -34.
3.
Click
or
to add or delete the pattern.
4.
Click
or
to adjust the order of sequence.
5.
Click
Apply.
6.1.13.3Delete a Digitmap
1.
Select a digitmap ID.
2.
Click
Del
to remove the ID.
85
