The following items are included in your Video Door Phone package. Check this list before
installation to ensure that you have received all items.
1
. Video Door Phone Unit
(with protective cover)
2
. Wall Mounting Box
(including L-IRON)
3
. Relay Board
4. 5-pin Terminal block +
2-pin Terminal block +
Cord End Terminal (7
pieces)
5
. Wall Mounted Screw
Pack
6
. 2-pin Terminal block +
Cord End Terminal (2
pieces)
7
. Hang Rod x2
8
. Fixing Tool
9
. Cable Ties x6
10
. Master RFID Card
11
. Quick Installation Guide & Quick Start Guide (English & Chinese)
In order to get better visual quality, this
product provides WL (white light) LED for
lighting at night or lower light condition. The
Lens of this device is able to see WL (White
Light) LED light. In order to get a better view,
the view angle of this door phone should be
around 105
o
. Also the height of the lens
position is suggested at the distance of 155
cm according to building conditions.
NOTE: Avoid eyes exposure to the beam of
the WL (White Light) LED for a long
time, or it may cause discomfort to
your eyes.
1.
Installing Wall Mounting Box
1. Put wall mounting box into wall hole, place a spirit
level (bubble level) on the wall mounting box, and
mark the four on the wall for drilling holes.
2. Drill four holes for wall screw anchors.
3. Hammer four wall screw anchors into the drilled
holes.
4. Remove L-Iron from wall mounting box by loosing
screws.
5.Secure four screws and washers to secure the wall
mounting box and secure four screws on L-Irons.
6. Tie four cable ties on the wall mounting box.
7. Again put wall mounting box into wall hole, secure
wall mounting box with L-Irons by securing four
screws.
8. Put Hang Rod in the cable ties, tie Hang Rods tightly on Wall Mounting Box to keep wall
mounting box parallel to the surface of the wall.
9. Place a spirit level (bubble level) on the wall mounting box, fasten L-Irons on the wall.
10. Fasten screws to fasten wall mounting box with L-Irons.
11. Remove Hang Rod and cable ties.
2.
Wire and Cable Connection
In the center of the wall mounting box, wire and cable go through the wall and are mainly used
for power, network connection, and relay control. There are IO connectors on the rear side of the
DP3010R. They are DC power, Ethernet port (RJ-45 connector), and GPIO wire.
3.
Connecting to Ground Wire
To prevent power surge and lighting strike from damaging
DP3010R, wall mounting box should be connected to the
ground wire (earth wire) of the building, and power
switching in public area for DP3010R should also be
connected to the ground wire (earth wire).
4.
Rear Cover & Waterproof Mat
Package Contents
Installing Procedures
Please contact your dealer immediately if any item(s) is missing.
Rear Panel & Side View
Installing Video Door Phone
When the wire
connection is
completed, we need to
select the “Positive” for
Electronic Bolt on the
GPIO page of Entrance
Setting on DP3010R
WEB User Interface.
800-0000018-00-00
