Temposonics
®
R-Series
V
POWERLINK
Operation Manual
I 5 I
3.1 Order code of Temposonics
®
RP5
3. Identification
a
Sensor model
R
P 5
Profi le
b
Design
G
Magnet slider backlash free (part no. 253 421),
suitable for internal linearization
L
Block magnet L (part no. 403 448)
M
U-magnet OD33 (part no. 251 416-2),
suitable for internal linearization
N
Magnet slider longer ball-jointed arm (part no. 252 183),
suitable for internal linearization
O
No position magnet
S
Magnet slider joint at top (part no. 252
182),
suitable for internal linearization
V
Magnet slider joint at front (part no. 252
184),
suitable for internal linearization
c
Mechanical options
A
Standard
V
Fluorelastomer seals for the sensor electronics housing
.
d
Stroke length
X X X X M
0025…6350 mm
Standard stroke length (mm)
Ordering steps
25… 500 mm
25 mm
500…2500 mm
50 mm
2500…5000 mm
100 mm
5000…6350 mm
250 mm
X X X X U
001.0…250.0 in.
Standard stroke length (in.)
Ordering steps
1… 20 in.
1.0 in.
20…100 in.
2.0 in.
100…200 in.
4.0 in.
200…250 in.
10.0 in.
Non-standard stroke lengths are available;
must be encoded in 5 mm/0.1 in. increments.
.
e
Number of magnets
X X
01…30 position(s) (1…30 magnet(s))
f
Connection type
D 5 6
2 × M12 female connectors (D-coded),
1 × M8 male connector
D 5 8
2 × M12 female connectors (D-coded),
1 × M12 male connector (A-coded)
g System
1
Standard
h Output
U 3 0 1
POWERLINK, position and velocity
(1…30 magnet(s))
U 3 1 1
POWERLINK, position and velocity,
internal linearization (1…30 magnet(s))
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
R
P 5
D 5
1
U 3
1
a
b
c
d
e
f
g
h
NOTICE
• For the RP5, the magnet selected in
b
“Design” is included in
the scope of delivery. Specify the number of magnets for your
application. For multi-position measurements with more than
1 magnet order the other magnets separately.
• The number of magnets is limited by the stroke length.
The minimum allowed distance between magnets (i.e. front face
of one to the front face of the next one) is 75 mm (3 in.).
• Use magnets of the same type for multi-position measurement.
• If the option for internal linearization (U311) in
h
“Output” is
chosen, select a suitable magnet.