Amphenol Temposonics R V Analog RDV, Operation Manual, Page: 62 / 71

Temposonics
®
R-Series
V
Analog
Operation Manual
I 62 I
8.2 Technical data Temposonics
®
RH5
Output
Analog Voltage: 0…10 /10…0/−10…+10/+10…−10 VDC (min. controller load > 5 k Ω )
Current: 4(0)…20/20…4(0) mA (min./max. load 0/500 Ω )
Measured output variables Position for one or two position magnets
Po speed (without direction) or velocity (with direction) for one position magnet
Position for one position temperature inside the sensor electronics housing
Measurement parameters
Position measurement
Null/Span adjustment 100 % of electrical stroke
Resolution 16 bit (internal resolution 0.1 µm)
Update time Stroke length ≤ 200 mm ≤ 350 mm ≤ 1200 mm ≤ 2400 mm ≤ 4800 mm ≤ 7620 mm
Update time 0.25 ms 0.333 ms 0.5 ms 1.0 ms 2.0 ms 5.0 ms
Linearity deviation
5
< ±0.01 % F.S. (minimum ±50 µm)
Repeatability < ±0.001 % F.S. (minimum ±1 µm)
Hysteresis < 4 µm typical
Temperature coefficient < 30 ppm/K typical
Velocity measurement
Range 0.01…10 m/s or 1…400 in./s
Deviation ≤ 0.05 %
Resolution 16 bit (minimum 0.01 mm/s)
Operating conditions
Operating temperature −40…+85 °C (−40…+185 °F)
Humidity 90 % relative humidity, no condensation
Ingress protection IP67 (connectors correctly fitted)/IP68 (3 m/3 d) for cable outlet
Shock test 150 g/11 ms, IEC standard 60068-2-27
Vibration test 30 g/10…2000 Hz, IEC standard 60068-2-6 (excluding resonant frequencies)/
RH5-J: 15 g / 10…2000 Hz, IEC standard 60068-2-6 (excluding resonant frequencies)
EMC test Electromagnetic emission according to EN 61000-6-3
Electromagnetic immunity according to EN 61000-6-2
The RH5 sensors fulfill the requirements of the EMC directives 2014/30/EU, UKSI 2016 No. 1091 and
TR CU 020/2011
Operating pressure 350 bar (5,070 psi)/700 bar (10,150 psi) peak (at 10 × 1 min) for sensor rod/RH5-J: 800 bar (11,600 psi)
Magnet movement velocity Any
Design/Material
Sensor electronics housing Aluminum (painted), zinc die cast
Sensor flange Stainless steel 1.4305 (AISI 303)
Sensor rod Stainless steel 1.4306 (AISI 304L)/RH5-J: Stainless steel 1.4301 (AISI 304)
RoHS compliance The used materials are compliant with the requirements of EU Directive 2011/65/EU and
EU Regulation 2015/863 as well as UKSI 2022 No. 622
Stroke length 25…7620 mm (1…300 in.)/RH5-J: 25…5900 mm (1…232 in.)
Mechanical mounting
Mounting position Any
Mounting instruction Please consult the technical drawings on page 17 and page 18
5/ With position magnet # 251 416-2
Technical data “Electrical connection” on page 63