Amphenol Fiber Optic Products – 2100 Western Court, Suite 300 – Lisle, IL 60532 – P (800) 944-6446 – F (630) 810-5880 www.amphenol-fiberoptics.com
Page 1 of 2
949-1690 Rev. B
Assembly Procedure for RJ Sealed Connectors
Procedure to be used for terminating and assembling of Amphenol Connector Kit Part Number 957-7610
Step 1:
Feed CAT cable through boot and connector housing as shown below.
Note: Care should be taken not to damage the rubber sealing gasket inside the rear of the
connector housing.
Step 2:
Terminate RJ-45 connector onto CAT cable
A) Strip jacketing and shield as shown
B) Fold shield back onto jacketing.
Wrap drain wire one and a half times
around the shield.
Trim excess length from drain wire
C) Untwist pairs and arrange to desired order.
Note: It is recommended to follow TIA-
568 specifications for wiring orientation
Trim conductors at an angle and insert into
the loading bar
D) Trim excess wire from holder
Insert prepared cable into RJ-45 Plug
