10
10
PLUG AND PLAY SETUP GUIDE
Connect your Pro Access Point to your Router
a)
Open the lid of the Pro Access Point and check that the PoE cable is securely fastened to the POE port
.
b)
Locate the PoE Adapter and connect the 30 ft PoE cable to the AP port on the PoE adapter
.
c)
Locate the power adapter and connect one end to a power outlet and the other end to the PWR port on the
back of the PoE adapter.
d)
Locate the shorter network cable and connect one end to the NETWORK port on the PoE adapter and the
other to your router’s network (LAN) port, or a network switch.
Note: Use only Ethernet cables that do NOT support PoE for this connection.
Allow up to 2 minutes for the Pro Access Point to configure itself to your network. (DHCP Networks Only)
