Ampcontrol gasguard, Installation, Operation & Maintenance Manual

Page: 29 / 79

GASGUARD IS CONTROLLER Issue: R2, Date: 26/09/2011, CRN: 7502
Page 28
4.4.5 Set Relay Start-Up Mode
5. To modify ‘PwrUpMode’ press the

key to enter
6. Use the

key to toggle between LIVE and LATCHED
7. To save, use the

key
8. To escape, use the

key
4.5 Output Configuration Menu
To view and modify the Output Configuration settings use the following procedure. This procedure can be applied to
the configuration of all three outputs. Note: Outputs are always 4-20mA even if the inputs are 0.4-2.0V types.
1. Once in the Configuration Main Menu, scroll down using

key to position 15 Output Configuration
2. Press

key to enter into sub-menu
4.5.1 Set Output Status
1. To modify ‘Status’ press the

key to enter
2. Use the

key to toggle between ON and OFF
3. To save, use the

key
4. To escape, use the

key
4.5.2 Set Output Tag Name
1. To modify ‘Output’ press the

key to enter
2. Use the

key to scroll through the alpha-numerals
3. Use the

key to move cursor across to the next digit
4. To save, use the

key
5. To escape, use the

key
4.5.3 Set Output Type
1. To modify ‘OP Type’ press the

key to enter
2. Use the

key to toggle between FOLLOW, HIGHEST, and LOWEST
3. To save, use the

key
4. To escape, use the

key
4.5.4 Set Output to Channel 1
1. To modify ‘CH1’ press the

key to enter
2. Use the

key toggle between IN and NOT IN
3. To save, use the

key
4. To escape, use the

key
4.5.5 Set Output to Channel 2
1. To modify ‘CH2’ press the

key to enter
2. Use the

key toggle between IN and NOT IN
3. To save, use the

key
4. To escape, use the

key