Ampcontrol gasguard, Installation, Operation & Maintenance Manual

Page: 27 / 79

GASGUARD IS CONTROLLER Issue: R2, Date: 26/09/2011, CRN: 7502
Page 26
4.3 Zone Configuration Menu
To view and modify the Zone Configuration settings use the following procedure. This procedure can be applied to
the configuration of all six Zones and for all four Channels.
1. Once in the Configuration Main Menu, scroll down using the

key to position 5; Zone Configuration.
2. Press

to enter into sub-menu.
4.3.1 Set Zone Status
1. To Modify ‘Status’ press the

key to enter
2. Use the

key to toggle between ON and OFF
3. To save, use the

key
4. To escape, use the

key
4.3.2 Set Zone Tag Name
1. To modify ‘TAG’ press the

key to enter
2. Use the

key to scroll through the alpha-numerals
3. Use the

key to move the cursor across to the next digit
4. To save, use the

key
5. To escape, use the

key
4.3.3 Set Zone 1 to Channel 1 /Low Fault Alarm
1. To modify ‘CH1 LF’ press the

key to enter
2. Use the

key to toggle between IN and NOT IN
3. To save, use the

key
4. To escape, use the

key
4.3.4 Set Zone 1 to Channel 1/Alarm 1
1. To modify ‘CH1 A1’ press the

key to enter
2. Use the

key to toggle between IN and /NOT IN
3. To save, use the

key
4. To escape, use the

key
4.3.5 Set Zone 1 to Channel 1/Alarm 2
1. To modify ‘CH1 A2’ press the

key to enter
2. Use the

key to toggle between IN and NOT IN
3. To save, use the

key
4. To escape, use the

key
4.3.6 Set Zone 1 to Channel 1/Alarm 3
1. To modify ‘CH1 A3’ press the

key to enter
2. Use the

key to toggle between IN and NOT IN
3. To save, use the

key
4. To escape, use the

key