Ampcontrol gasguard, Installation, Operation & Maintenance Manual

Page: 25 / 79

GASGUARD IS CONTROLLER Issue: R2, Date: 26/09/2011, CRN: 7502
Page 24
4.2.3 Set Gas Name
The controller has 6 pre-set gas types: CH
4
, CO, O
2
, H
2
S, AV and DP. If another gas type is required the operator
can select the User Function to input the desired gas type.
1. To modify ‘Gas Name’ press

key to enter
2. Use the

key to scroll through the Gas names
3. To save, use the

key or
4. To input another Gas name, scroll to ‘User’ by pressing the

key
5. Use the

key to enter into ‘User’
6. Enter the desired name by pressing

key to scroll through the alpha-numerals
7. Press the

key to move the cursor across to the next segment
8. Once the desired Gas name has been entered, use the

key to save
9. To escape, use the

key
4.2.4 Set Decimal Point
Required to set correct gas reading
1. To modify ‘Dec Pt’ press

key to enter
2. Use the

key to move the decimal point to the required position
3. To save, use the

key
4. To escape, use the

key
4.2.5 Set Full Scale
Required to set correct gas reading
1. To modify ‘FS’ press

to enter
2. Use the

key to scroll through the numbers
3. Use the

key to move the cursor across to the required alpha-numeral setting
4. To save, use the

key
5. To escape, use the

key
4.2.6 Set Units of Measure
Required to set correct gas reading
1. To modify ‘Units’ press

to enter
2. Use the

key to scroll through the Units
3. To save, use the

key
4. To escape, use the

key
4.2.7 Set Tag Name
Enables customer to assign a name to the controller for identification purposes
1. To modify ‘Tag’ press

to enter
2. Use the

key to scroll through the alpha-numerals
3. Use the

key to move the cursor across to the next digit
4. To save, use the

key
5. To escape, use the

key