Ammann ARX 36, Original Manual

Page: 63 / 152

Operation 63
120
8531
|
03.
07.
2012
4a to position 0: The engine stops.
4b to position P: The parking lights will be switched on.
NOTE The hazard warning light can be switched on and off independently of the ig-
nition key position.
7.8 Parking brake
Parking brake All rollers are equipped with a parking brake switch. This switch activates the parking
brake compulsorily. In this condition, the roller neither be moved nor can the vibration
be activated. This function can be used to prevent the roller from slowly rolling on slo-
pes.
The driver must activate the parking brake when leaving the roller.
NOTE Increased parking brake wear.
• The parking brake may not be activated while driving, but only when the rol-
ler is at a standstill.
7.9 Seat switch
The roller can only be put into operation when the seat switch is closed, i.e. the driver
is seated on the driver's seat.
7.9.1 Opening the seat switch
If the seat switch is opened during operation (the driver stands up), the roller will stop
after a brief delay of 0.7sec.
NOTE The seat switch can be opened when:
• the driver leans out to the side and no longer sits on the seat with his full
weight.
• the driver is too light. In this case, adjust the seat for the driver using the
weight adjustment.
7.9.2 Closing the seat switch
1 Put the operating lever into the neutral position.
1.1 You can leave the speed adjusting lever in its previous position.
2 Start the roller by moving the operating lever.