Ammann ARR 1575 Yanmar, Operating Manual

Page: 82 / 146

76 ARR 1575
550083A
3 3
2 2
1
1
555094
2.8. How to transport the Machine
• The machine can move on its own between working sites.
When moving on the working site, observe the safety
measures applicable to the working site.
When driving for long distances, 1-hour cooling breaks
after 3 hours of driving should be taken. Failing that, you
are exposed to the risk of damage to the machine for
which the manufacturer is not responsible.
• When on the road, the machine should be transported on
a vehicle.
When transporting the machine on a vehicle, observe
the regulations in force in the given territory.
Make sure the transport carrier is braked and mechani-
cally secured against undesired motion with scotch
blocks (3) when loading or unloading.
When moving onto the transport carrier you must switch
ON the function of Drum Slip Limitation. At the same
time we recommend to put rubber bands or wooden
planks, etc. underneath the drum.
The machine on the vehicle must be properly tied and
mechanically secured against longitudinal and lateral
displacement as well as against tipping (1). The drums
must be secured using scotch blocks (2).The maximum
force permitted for tying the machine to a transport ve-
hicle is 2.5 t.
Center of gravity
The center of gravity relevant to transport is located 460 mm
from the floor and approx. in the center of the machine, de-
pending on the fill level of the diesel or water tanks.